CLLE1AX7S0G225M-0.95 Datasheet, PDF (7/13 Pages) TDK Electronics – Ultra Low Inductance Capacitors

General
Specifications
CLL Series – ULI Capacitors
No. Item
Performance
Test or Inspection Method
9
Resistance to solder heat
Completely soak both terminations in solder at
External
260±5ºC for 5±1s.
No cracks are allowed and terminations
appearance
shall be covered at least 60% with new
solder
Preheating condition
Temp. : 150±10ºC
Capacitance
D.F. (Class 2)
Insulation
Characteristics
X7R
X7S
Change from the
value before test
± 7.5 %
Meet the initial spec.
Meet the initial spec.
Time : 1 to 2min.
Flux : Isopropyl alcohol (JIS K 8839)
Rosin (JIS K 5902) 25% solid solution.
Solder : H63A (JIS Z 3282)
Leave the capacitor in ambient conditions for 24±2h
before measurement.
Resistance
10
Vibration
External
appearance
Capacitance
No mechanical damage.
Characteristics
X7R
X7S
Change from the
value before test
± 7.5 %
Reflow solder the capacitor on a P.C. board (shown in
Appendix 1 and 2) before testing.
Vibrate the capacitor with amplitude of1.5mm P-P
sweeping the frequencies from 10Hz to 55Hz and back
to 10Hz in about 1 minute.
Repeat this for 2h each in 3 perpendicular directions
(6h in total).
D.F. (Class 2)
Meet the initial spec.
11
Temperature cycle
External
appearance
No mechanical damage.
Capacitance
Characteristics
X7R
X7S
Change from the
value before test
± 7.5 %
D.F. (Class 2)
Insulation
Resistance
Voltage Proof
Meet the initial spec.
Meet the initial spec.
No insulation breakdown or other
damage.
Reflow solder the capacitors on a P.C. board (shown in
Appendix 1 and 2) before testing.
Expose the capacitor in the condition step1 through
step 4, and repeat 5 times consecutively.
Leave the capacitor in ambient conditions for 24±2h
before measurement.
Step
1
2
3
4
Temperature (ºC)
Min. operating temp. ±3
Reference Temp.
Max. operating temp. ± 2
Reference Temp.
Time (min.)
30 ± 3
2–5
30 ± 2
2-5
TDK MLCC US Catalog
Page 235
Version B11