W77E058A40DL Datasheet, PDF (43/87 Pages) Nuvotem Talema – GENERAL DESCRIPTION

W77E058A
8.4 Wait State Control Signal
Either with the software using stretch value to change the required machine cycle of MOVX instruction,
the W77E058 provides another hardware signal WAIT to implement the wider duration of external
data access timing. This wait state control signal is the alternate function of P4.0 such that it can only
be invoked to 44-pin PLCC/QFP package type. The wait state control signal can be enabled by setting
WS (ROMMAP.7) bit. When enabled, the setting of stretch value decides the minimum length of
MOVX instruction cycle and the device will sample the WAIT pin at each C3 state before the rising
edge of read/write strobe signal during MOVX instruction. Once this signal being recongnized, one
more machine cycle (wait state cycle) will be inserted into next cycle. The inserted wait state cycles
are unlimited, so the MOVX instruction cycle will end in which the wait state control signal is
deactivated. Using wait state control signal allows a dynamically access timimg to a selected external
peripheral. The WS bit is accessed by the Timed Access Protection procedure.
Set WS bit ahd stretch value = 0 to enable wait signal.
- 43 -
Publication Release Date: April 17, 2007
Revision A10