English
Language : 

PQ60150EKXXX Datasheet, PDF (13/15 Pages) SynQor Worldwide Headquarters – Thermal shutdown protects converter from abnormal environmental conditions
Technical Specification
Input: 35-75V
Output: 15V
Current: 3.3A
Part No.: PQ60150EKx03
APPLICATION CONSIDERATIONS
Input System Instability: This condition can occur because
any DC/DC converter appears incrementally as a negative
resistance load. A detailed application note titled “Input System
Instability” is available on the SynQor website which provides
an understanding of why this instability arises, and shows the
preferred solution for correcting it.
Application Circuits: Figure D below provides a typical circuit
diagram which details the input filtering and voltage trimming.
Input Filtering and External Capacitance: Figure E below
provides a diagram showing the internal input filter components.
This filter dramatically reduces input terminal ripple current,
which otherwise could exceed the rating of an external
input electrolytic capacitor. The recommended external input
capacitance is specified in the “Input Characteristics” section.
More detailed information is available in the application note
titled “EMI Characteristics” on the SynQor website.
Startup Inhibit Period: The Startup Inhibit Period ensures
that the converter will remain off for approximately 200ms
when it is shut down for any reason. In all, there are five ways
that the converter can be shut down, initiating a Startup Inhibit
Period:
• Input Under-Voltage Lockout
• Output Over-Voltage Protection
• Over Temperature Shutdown
• Current Limit
• Turned off by the ON/OFF input
Vin(+)
Vout(+)
Electrolytic
Vsense(+)
Vin
External
Input
Capacitor
47µF
ON/OFF
Rtrim-up
Trim
or
Filter
Vsense(_)
Rtrim-down Cload
Iload
Vin(_)
Vout(_)
Figure D: Typical application circuit (negative logic unit, permanently enabled).
L
Vin(+)
C
Vin(_)
Figure E: Internal Input Filter Diagram (component values listed on the specifications page).
Product # PQ60150EKx03
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-0005265 Rev. A
08/20/09
Page 13