PQ60025QPA60 Datasheet, PDF (12/14 Pages) SynQor Worldwide Headquarters – Quarter-brick DC/DC Converter

Technical Specification
Input: 35-75 V
Output: 2.5 V
Current: 60 A
Package: Quarter-brick
again when the temperature of the sensed location falls by the
amount of the Over-Temperature Shutdown Restart Hysteresis
value.
“EMI Characteristics” on the SynQor website.
APPLICATION CONSIDERATIONS
Input System Instability: This condition can occur because
any DC/DC converter appears incrementally as a negative
resistance load. A detailed application note titled “Input
System Instability” is available on the SynQor web site
(www.synqor.com) which provides an understanding of why
this instability arises, and shows the preferred solution for cor-
recting it.
Application Circuits: Figure D below provides a typical cir-
cuit diagram which details the input filtering and voltage trim-
ming.
Input Filtering and External Capacitance: Figure E below
provides a diagram showing the internal input filter components.
This filter dramatically reduces input terminal ripple current,
which otherwise could exceed the rating of an external elec-
trolytic input capacitor. The recommended external input capac-
itance is specified in the “Input Characterisitcs” section. More
detailed information is available in the application note titled
Vin(+)
Vout(+)
Electrolytic
Vsense(+)
Vin
External
Input
Capacitor
47µF
ON/OFF
R_trim-up
Trim
or
Filter
Vsense(^_)
R_trim-down C_load
I_load
Vin(^_)
Vout(^_)
Figure D: Typical application circuit (negative logic unit, permanently enabled).
L
Vin(+)
C
Vin(^_)
Figure E: Internal Input Filter Diagram (component values listed on page 3).
Product # PQ60025QPA60
Phone [phone]
www.synqor.com
Doc.# 005-2QP625F Rev. A 12/10/04
Page 12