SMH4044 Datasheet, PDF (7/20 Pages) Summit Microelectronics, Inc. – Compact PCI Hot-Swap Controller With IPMI Support

SMH4044
Preliminary
LOCAL_PCI_RST (29)
An open-drain (PFET) active-high output. It operates
together with with LOCAL_PCI_RST#, providing an ac-
tive high reset signal which is required by many 8051 style
MCUs. It is active whenever the card-side monitor inputs
are below their respective VTRIP levels. It may also be
driven active by a low input on the PCI_RST# pin.
SGNL_VLD# (20)
An open-drain, active-low output that indicates card side
power is valid and the internal card side PCI_RST# timer
has timed out.
1VREF (2)
This output provides a 1V reference for pre-charging the
bus signal pins. Implementing a simple unity gain
amplifier circuit will allow pre-charging a large number of
pins.
MONITOR1, MONITOR2 (6, 30)
Voltage sensor inputs which will detect voltages and
compare them to the internal 1.25V reference. The
sensors can be independently configured to sense over
voltage or under voltage and can be used as either Host
side voltage sensors or Card side voltage sensors.
VGATE3 (34)
A slew rate limited high side driver output for the 3.3V
external power FET gate. The output-voltage is generated
by an on-board charge pump.
VGATE5 (41)
A slew rate limited high side driver output for the 5V
external power FET gate. The output voltage is generated
by an on-board charge pump.
CS# (32)
An active low Chip Select input. This signal must be
asserted during I²C communications. The CS# signal
allows external decoding to be used to extend the number
of SMH4044 devices on the same serial bus from 8 —
using the Address inputs — to an unlimited number. Bus
Capacitive and Resistance loading must be considered
when using multiple I²C devices on the same bus. Please
refer to generic I²C documentation ("Bus Interface") in
this Data Sheet for further information.
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias ...................... –55°C to 125°C
Storage Temperature ........................... –65°C to 150°C
Lead Solder Temperature (10 secs) .................. 300 °C
Terminal Voltage with Respect to GND:
V₀, V₁, V₂, and V₃ .......... –0.3V to 6.0V
All Others ...................... –0.3V to 6.0V
*COMMENT
Stresses listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions
outside those listed in the operational sections of this specification is not
implied. Exposure to any absolute maximum rating for extended
periods may affect device performance and reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature –40ºC to 85ºC.
Voltage
2.7V to 5.5V
SUMMIT MICROELECTRONICS, Inc.
2057 1.x 8/16/01
7