STCC5011 Datasheet, PDF (9/37 Pages) STMicroelectronics – Constant current mode overcurrent protection

STCC5011, STCC5021
Electrical characteristics
Table 4. Electrical characteristics V_IN = 4.5 V to 5.5 V, V_DD = 1.7 V to 5.5 V, -40 °C < T_J < 125 °C
(unless otherwise specified) (continued)
Symbol
Parameter
Conditions
Min. Typ. Max. Unit
t_ATTACH
CHARGING/ATTACH
assertion time after attach
detected
25
s
High-speed data switch - DC parameters
R_ON
Data switch on-resistance
R_ON
Data switch on-resistance
I_OFF
OFF state leakage current
High-speed data switch - AC parameters⁽¹⁾
Switch closed, V_IN = 5 V,
I_S = 8 mA, test voltage on
DP_OUT, DM_OUT = 0.4 V
Switch closed, V_IN = 5 V,
I_S = 8 mA, test voltage on
DP_OUT, DM_OUT = 3 V
V_EN = 0 V, VDP/DM_IN = 3.6 V,
VDP/DM_OUT = 0 V, measure
IDP/DM_OUT
2.5 4
Ω
2.7 4
1.5 µA
X_TALK
O_IRR
B_w
DP, DM crosstalk
OFF state isolation
Bandwidth -3 dB
R_TERM = 50 Ω, C_LOAD = 5 pF,
V_S = 1 V_rms, signal = 0 dBm,
f = 250 MHz
R_TERM = 50 Ω, C_LOAD = 5 pF,
V_S = 1 V_rms, signal = 0 dBm,
f = 250 MHz
R_TERM = 50 Ω, C_LOAD = 5 pF,
signal = 0 dBm
47
17
1100
dB
MHz
Charger emulator - BC1.2 DCP mode
R_{DCP_RES}
DP_IN to DM_IN short
resistance
CTLx configured for DCP BC1.2
100 170 Ω
Charger emulator - divider mode
V_{DM_1A}
V_{DP_1A}
R_{DM_1A}
R_{DP_1A}
V_{DM_2A}
V_{DP_2A}
DM_IN output voltage
DP_IN output voltage
DM_IN output resistance
DP_IN output resistance
DM_IN output voltage
DP_IN output voltage
STCC5011, device set to DCP ^{2.65 2.7 2.75}
auto-detect mode or divider
V
mode, V_IN = 5.0 V
1.96 2 2.04
STCC5011, device set to DCP
auto-detect mode or divider
mode, V_IN = 5.0 V
27
kΩ
27
STCC5021, device set to DCP ^{1.96 2 2.04}
auto-detect mode or divider
V
mode, V_IN = 5.0 V
2.65 2.7 2.75
DocID024660 Rev 6
9/37
37