AN987 Datasheet, PDF (8/10 Pages) STMicroelectronics – ST7 SERIAL TEST CONTROLLER PROGRAMMING

ST7 SERIAL TEST CONTROLLER PROGRAMMING
4 APPENDIX 2
This appendix provides the required information for programming a device supported by the
MDT1, MDT2 and MDT4 EPBs or starter kits. The five JTAG pins and three test mode pins
(M0, M1 and M2) with their associated pin numbers are specified for each device.
4.1 ST7 MDT1 EPB OR STARTER KIT
ST7 Device
Pin Numbers
Sales type
EPROM E² RAM
JTDI JTCK JTRST JTMS JTDO
Package
M2
M1
M0
Vpp Reset Oscin Vdd Vss
PA3 PA2 PA1 PA0 PC3 PB2 PB1 PB0
ST72x101G1 4K
- 256 ^{SO28 22 23}
24
25 14 9 10 11 26 1
SDIP32 26 27
28
29 16 11 12 13 30 1
2 28 27
2 32 31
ST72x101G2 8K
- 256 ^{SO28 22 23}
24
25 14 9 10 11 26 1
SDIP32 26 27
28
29 16 11 12 13 30 1
2 28 27
2 32 31
SO28 22 23
24
25 14 9 10 11 26 1
ST72x212G2 8K
- 256 _{SDIP32 26 27}
28
29 16 11 12 13 30 1
2 28 27
2 32 31
SO28 22 23
24
25 14 9 10 11 26 1
ST72x213G1 4K
- 256 _{SDIP32 26 27}
28
29 16 11 12 13 30 1
2 28 27
2 32 31
ST72x251G1 4K
-
256
SO28
SDIP32
22
26
23
27
24
28
25 14 9 10 11 26 1
29 16 11 12 13 30 1
2 28 27
2 32 31
SO28 22 23
24
25 14 9 10 11 26 1
ST72x251G2 8K
- 256 _{SDIP32 26 27}
28
29 16 11 12 13 30 1
2 28 27
2 32 31
Programming tool W1 connector
51
9
3 7 12 10 8 16 4 2 N.C 15
x = T, if the device is an OTP,
E, if the device is an EPROM,
N.C., means not connected.
8/10