AN987 Datasheet, PDF (6/10 Pages) STMicroelectronics – ST7 SERIAL TEST CONTROLLER PROGRAMMING

ST7 SERIAL TEST CONTROLLER PROGRAMMING
2.3 PROGRAMMING PROCEDURE
Depending on the device you need to program, use one of these ST7 programming tools:
s ST7 MDT1-KIT or ST7 MDT1-EPB. They cover the following devices:
– ST72101G1 or G2
– ST72212G2
– ST72213G1
– ST72251G1 or G2
s ST7 MDT2-KIT or ST7 MDT4-EPB. They cover the following devices:
– ST72121J2 or J4
– ST72311J2 or J4
– ST72311N2 or N4
– ST72331J2 or J4
– ST72331N2 or N4
s ST7 MDT4-KIT or ST7 MDT4-EPB. They cover the following devices:
– ST72272K2 or K4
– ST72372J4
– ST72371N4
– ST72671N4 or N6
After selecting the appropriate programming tool, proceed as follows:
1. On the application board, remove all jumpers.
2. Locate the 16 pin connector W1 (8x2 header HE10) on the programming tool which con-
tains the 12 signals necessary for performing STCP (see Section 3 APPENDIX 1 for the pin
identification).Then connect the W1 connector of the programming tool to the application
board connector (J1 in Figure 1.).
3. Using the parallel interface cable, connect the PC parallel port to the parallel connector of
the programming tool.
4. Power on the PC and the board. On the programming tool, LED 1 must light up.
5. Start the Windows EPROMer, target the programming tool, then the correct device. Open
the file containing the code to program. And... program your device!
6. Close the operating software, power down the programming tool, disconnect the applica-
tion board from the programming tool and replace any jumpers that were disconnected on
the application board. Your application is now ready to run!
6/10