English
Language : 

RHFLVDS2281 Datasheet, PDF (7/17 Pages) STMicroelectronics – Rad-hard, dual 4x4 crosspoint switch LVDS
RHFLVDS2281
4
Electrical characteristics
Electrical characteristics
Total dose (MIL-STD-883 TM 1019)
The products guaranteed in radiation within the RHA QML-V system fully comply with the
MIL-STD-883 TM 1019 specification.
The RHFLVDS2281 is RHA QML-V, tested and characterized in full compliance with the 
MIL-STD-883 specification, between 50 and 300 rad/s only (full CMOS technology).
All parameters provided in Table 7: Electrical characteristics table apply to both pre- and
post-irradiation, as follows:
 All test are performed in accordance with MIL-PRF-38535 and test method 1019 of
MIL-STD-883 for total ionizing dose (TID).
 The initial characterization is performed in qualification only on both biased and
unbiased parts.
 Each wafer lot is tested at high dose rate only, in the worst bias case condition, based
on the results obtained during the initial qualification.
Heavy ions
The behavior of the product when submitted to heavy ions is not tested in production.
Heavy-ion trials are performed on qualification lots only.
Type
TID
Heavy ions
Table 6. Radiations
Characteristics
High-dose rate (50 - 300 rad/sec)
SEL immunity up to:
(with a particle angle of 60 °, at 125 °C)
SEL immunity up to:
(with a particle angle of 0 °, at 125 °C)
SET/SEU immunity up to:
(at 25 °C)
Value
300
135
67
22
Unit
krad
MeV.cm2/mg
DocID027588 Rev 1
7/17
17