RM0383 Datasheet, PDF (532/837 Pages) STMicroelectronics – This Reference manual targets application developers

Universal synchronous asynchronous receiver transmitter (USART)
RM0383
Note:
IrDA low-power mode
Transmitter:
In low-power mode the pulse width is not maintained at 3/16 of the bit period. Instead, the
width of the pulse is 3 times the low-power baud rate which can be a minimum of 1.42 MHz.
Generally this value is 1.8432 MHz (1.42 MHz < PSC< 2.12 MHz). A low-power mode
programmable divisor divides the system clock to achieve this value.
Receiver:
Receiving in low-power mode is similar to receiving in normal mode. For glitch detection the
USART should discard pulses of duration shorter than 1/PSC. A valid low is accepted only if
its duration is greater than 2 periods of the IrDA low-power Baud clock (PSC value in
USART_GTPR).
A pulse of width less than two and greater than one PSC period(s) may or may not be
rejected.
The receiver set up time should be managed by software. The IrDA physical layer
specification specifies a minimum of 10 ms delay between transmission and reception (IrDA
is a half duplex protocol).
Figure 184. IrDA SIR ENDEC- block diagram
TX
USART
SIREN
OR
SIR
Transmit
Encoder
USART_TX
IrDA_OUT
SIR
RX
Receive
IrDA_IN
Decoder
USART_RX
TX
IrDA_OUT
IrDA_IN
Figure 185. IrDA data modulation (3/16) -Normal mode
Start
bit
0
1
01
0
bit period
stop bit
0
1
1
01
3/16
RX
0
1
0
1
0
0
1
1
0
1
532/836
DocID026448 Rev 1