STM32L15XCC Datasheet, PDF (52/136 Pages) STMicroelectronics – Reset and supply management

Electrical characteristics
6
Electrical characteristics
STM32L151xC STM32L152xC
6.1
6.1.1
Parameter conditions
Unless otherwise specified, all voltages are referenced to V_SS.
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T_A = 25 °C and T_A = T_Amax (given by
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes. Based on characterization, the minimum and maximum
values refer to sample tests and represent the mean value plus or minus three times the
standard deviation (mean ±3σ).
6.1.2
Typical values
Unless otherwise specified, typical data are based on T_A = 25 °C, V_DD = 3.6 V (for the
1.65 V ≤V_DD ≤3.6 V voltage range). They are given only as design guidelines and are not
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ±2σ).
6.1.3
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
6.1.4
Loading capacitor
The loading conditions used for pin parameter measurement are shown in Figure 10.
6.1.5
Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 11.
Figure 10. Pin loading conditions
Figure 11. Pin input voltage
& S)
0&8SLQ
0&8SLQ
9_,1
52/136
DLF
DocID022799 Rev 12
DLG