|
AN4128 Datasheet, PDF (14/28 Pages) STMicroelectronics – This document describes the STEVAL-SPBT4ATV3 demonstration board | |||
|
◁ |
Getting started
AN4128
with the following parameters:
â Select the proper COM line (COM1, COM2â¦â¦)
â Set baud rate = 115000 (default baud rate of SPBT2632C1A.AT2 module)
â Set data bits= 8
â Set stop bits= 1
â Set parity= none
â Set flow control= none
From the menu file set the AT command connection properties:
Figure 18. Connection properties setup
!-V
The dongle is ready to use:
â Press the reset switch on the dongle
â On the screen, the prompt followed by the module Bluetooth address should
appear:
Figure 19. AT command prompt
âAT-AB -CommandMode -â
âAT-AB BDAddress xxxxxxxxxxxxâ
14/28
Doc ID 023306 Rev 1
|
▷ |