STM32F103ZCH6 Datasheet, PDF (106/130 Pages) STMicroelectronics – High-density performance line ARM-based 32-bit MCU with 256 to 512KB Flash, USB, CAN, 11 timers, 3 ADCs, 13 communication interfaces

Electrical characteristics
STM32F103xC, STM32F103xD, STM32F103xE
Figure 58. Typical connection diagram using the ADC
RAIN(1)
AINx
VAIN
Cparasitic
VDD
VT
0.6 V
VT
0.6 V
IL±1 µA
STM32F103xx
Sample and hold ADC
converter
RADC(1)
12-bit
converter
CADC(1)
ai14150c
1. Refer to Table 59 for the values of R_AIN, R_ADC and C_ADC.
2. C_parasitic represents the capacitance of the PCB (dependent on soldering and PCB layout quality) plus the
pad capacitance (roughly 7 pF). A high C_parasitic value will downgrade conversion accuracy. To remedy
this, f_ADC should be reduced.
General PCB design guidelines
Power supply decoupling should be performed as shown in Figure 59 or Figure 60,
depending on whether V_REF+ is connected to V_DDA or not. The 10 nF capacitors should be
ceramic (good quality). They should be placed them as close as possible to the chip.
Figure 59. Power supply and reference decoupling (V_REF+ not connected to V_DDA)
STM32F103xx
V_REF+
(see note 1)
1 µF // 10 nF
1 µF // 10 nF
V_DDA
V_SSA /V_REF–
(see note 1)
ai14388b
1. V_REF+ and V_REF– inputs are available only on 100-pin packages.
106/130
Doc ID 14611 Rev 8