ICX062AL Datasheet, PDF (9/16 Pages) Sony Corporation – Diagonal 11mm (Type 2/3) CCD Image Sensor for EIA B/W Video Camera

ICX062AL
Image Sensor Characteristics
(Ta = 25°C)
Item
Symbol Min. Typ. Max. Unit Measurement method Remarks
Sensitivity
S
350 600
mV
1
Saturation signal
Vsat
800
mV
2
Ta = 60°C
Smear
Sm
0.0003 0.002 %
3
Video signal shading
SH
25
%
4
Dark signal
Dark signal shading
Flicker
Vdt
∆Vdt
F
2
mV
1
mV
5
%
5
Ta = 60°C
6
Ta = 60°C
7
Lag
Lag
0.5 %
8
Image Sensor Characteristics Measurement Method
Measurement conditions
1) In the following measurements, the substrate voltage and the reset gate clock voltage are set to the values
indicated on the device, and the device drive conditions are at the typical values of the bias and clock
voltage conditions.
2) In the following measurements, spot blemishes are excluded and, unless otherwise specified, the optical
black (OB) level is used as the reference for the signal output, and the value measured at point [^∗A] in the
Drive Circuit is used.
Definition of Standard Imaging Conditions
1) Standard imaging condition I: Use a pattern box (luminance 706cd/m², color temperature of 3200K halogen
source) as a subject. (Pattern for evaluation is not applicable.) Use a testing standard lens with CM500S
(t = 1.0mm) as an IR cut filter and image at F8. The luminous intensity to the sensor receiving surface at this
point is defined as the standard sensitivity testing luminous intensity.
2) Standard imaging condition II: Image a light source with a uniformity of brightness within 2% at all angles.
Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut filter. The luminous intensity is adjusted
to the value indicated in each testing item by the lens diaphragm.
1. Sensitivity
Set to standard imaging condition I. After selecting the electronic shutter mode with a shutter speed of
1/250s, measure the signal output (Vs) at the center of the screen and substitute the value into the
following formula.
S = Vs × ²⁵⁰ [mV]
60
2. Saturation signal
Set to standard imaging condition II. After adjusting the luminous intensity to 10 times the intensity with
average value of the signal output is 200mV, measure the minimum value of the signal output.
–9–