ICX282AKF Datasheet, PDF (17/48 Pages) Sony Corporation – Diagonal 11mm (Type 2/3) Frame Readout CCD Image Sensor with Square Pixel for Color Cameras

ICX282AKF
5. Video signal shading
Set to the standard imaging condition II. With the lens diaphragm at F5.6 to F8, adjusting the luminous
intensity so that the average value of the G/Mg/Ye/Cy channel signal output is 200mV. Then measure the
maximum value (Vmax [mV]) and minimum value (Vmin [mV]) of the G/Mg/Ye/Cy channel signal output
and substitute the values into the following formula.
SH = (Vmax – Vmin)/150 × 100 [%]
6. Dark signal
Measure the average value of the signal output (Vdt [mV]) with the device ambient temperature of 60°C
and the device in the light-obstructed state, using the horizontal idle transfer level as a reference.
7. Dark signal shading
After measuring 6, measure the maximum (Vdmax [mV]) and minimum (Vdmin [mV]) values of the dark
signal output and substitute the values into the following formula.
∆Vdt = Vdmax – Vdmin [mV]
8. Lag
Adjust the G/Mg/Ye/Cy channel output generated by the strobe light to 150mV. After setting the strobe light
so that it strobes with the following timing, measure the residual signal amount (Vlag). Substitute the value
into the following formula.
Lag = (Vlag/150) × 100 [%]
VD
V1A/V1B/V1C
Strobe light timing
Output
Light
G/Mg/Ye/Cy channel
signal output 150mV
Vlag (lag)
– 17 –