COM20019I_06 Datasheet, PDF(33/65 Page) SMSC Corporation – Low Cost ARCNET (ANSI 878.1) Controller with 2K x 8 On-Board RAM

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

COM20019I_06 Datasheet, PDF (33/65 Pages) SMSC Corporation – Low Cost ARCNET (ANSI 878.1) Controller with 2K x 8 On-Board RAM

◁

Low Cost ARCNET (ANSI 878.1) Controller with 2K x 8 On-Board RAM

BIT

BIT NAME

3,2,1 Clock Prescaler

Bits 3,2,1

Slow Arbitration

Select

SYMBOL

CKP3,2,1

SLOWARB

DESCRIPTION

These bits are used to determine the data rate of the

COM20019I. The following table is for a 20 MHz crystal:

CKP3 CKP2 CKP1 DIVISOR SPEED

312.5 Kbs

128

156.25 Kbs

Note: The lowest data rate achievable by the COM20019I

is 156.25 Kbs. Defaults to 011 or 312.5 Kbps.

This bit, when set, will divide the arbitration clock by 2.

Memory cycle times will increase when slow arbitration is

selected.

Defaults to low.

BIT

BIT NAME

Read Bus Timing

Select

6,5,4 Reserved

Enhanced

Functions

No Synchronous

1,0 Reconfiguration

Timer 1, 0

Table 6.11 - Setup 2 Register

SYMBOL

DESCRIPTION

RBUSTMG This bit is used to Disable/Enable the High Speed CPU

Read function for High Speed CPU bus support.

RBUSTMG=0: Disable (Default), RBUSTMG=1: Enable. It

does not influence write operation. High speed CPU Read

operation is only for non-multiplexed bus.

These bits are undefined.

This bit is used to enable the new enhanced functions in the

COM20019I. EF = 0: Disable (Default), EF = 1: Enable. If

EF = 0, the timing and function is the same as in the

COM20020, Revision B. See appendix âAâ. EF bit must be

â1â if the data rate is over 5Mbps.

EF bit should be â1â for new design customers.

EF bit should be â0â for replacement customers.

NOSYNC

This bit is used to enable the SYNC command during

initialization. NOSYNC= 0, Enable (Default) The line must

be idle for the RAM initialization sequence to be written.

NOSYNC= 1, Disable:) The line does not have to be idle for

the RAM initialization sequence to be written. See appendix

âAâ.

RCNTM1,

These bits are used to program the reconfiguration timer as

a function of maximum node count. These bits set the time

out period of the reconfiguration timer as shown below. The

time out periods shown are for 312.5 Kbps.

RCNTM1 RCNTM0 Time Out

Period

Max Node Count

6.72 S

Up to 255 nodes

1.68 S

Up to 64 nodes

840 mS

Up to 32 nodes

420 mS*

Up to 16 nodes

Note*: The node ID value 255 must exist in the network for

420 mS timeout to be valid.

SMSC COM20019I

Page 33

DATASHEET

Rev. 03-07-06

▷