English
Language : 

SKY66111-11 Datasheet, PDF (8/14 Pages) Skyworks Solutions Inc. – Low-Power Bluetooth Low Energy Front-End Module for Range Extension Applications
DATA SHEET • SKY66111-11: LOW-POWER BLUETOOTH LOW ENERGY FEM
Evaluation Board Description
The SKY66111-11 Evaluation Board is used to test the
performance of the SKY66111-11 front-end module. The board is
optimized for evaluation, experimentation, and investigation with
a Bluetooth Low Energy signal source. The design and layout can
be quickly and easily transferred into a production design.
An Evaluation Board schematic is provided in Figure 11. A
reference design schematic is provided in Figure 12. Table 10
provides the Bill of Materials (BOM) list for Evaluation Board
components. A photograph of the Evaluation Board is shown in
Figure 13.
Evaluation Board Setup Procedure
Connect Supply
1. Connect J1 and J4 to 50  instruments. Terminate all unused
ports (if applicable) with 50 .
2. Connect the supply ground to Pins 1, 4, and 6 of J2.
3. Connect 3.3 V to pin 7 of J2.
4. Connect 1.8 V to one of the logic pins (pin 3 or pin 5) on J2 to
select RX or TX mode. For TX mode, also connect pin 2 to
1.8 V. Connect the other logic pin to ground. Refer to Table 8
for mode control settings.
Package Dimensions
The PCB layout footprint for the SKY66111-11 is provided in
Figure 14. Typical part markings are shown in Figure 15. Package
dimensions are shown in Figure 16, and tape and reel dimensions
are provided in Figure 17.
Package and Handling Information
Since the device package is sensitive to moisture absorption, it is
baked and vacuum packed before shipping. Instructions on the
shipping container label regarding exposure to moisture after the
container seal is broken must be followed. Otherwise, problems
related to moisture absorption may occur when the part is
subjected to high temperature during solder assembly.
The SKY66111-11 is rated to Moisture Sensitivity Level 3 (MSL3)
at 260 C. It can be used for lead or lead-free soldering. For
additional information, refer to the Skyworks Application Note,
PCB Design and SMT Assembly/Rework Guidelines for MCM-L
Packages, document number 101752.
Care must be taken when attaching this product, whether it is
done manually or in a production solder reflow environment.
Production quantities of this product are shipped in a standard
tape and reel format.
Measure Performance
TX
Monitor the 2.4 GHz amplifier performance by applying an RF
signal to connector J4 (TR) and verify the output power on
connector J1 (ANT).
RX
Monitor the 2.4 GHz switch performance by applying an RF signal
to connector J1 (ANT) and verify the output signal on connector J4
(TR).
CAUTION: Care should be taken not to overdrive the switch by
applying too much RF on the input to the device. A
starting input power of −20 dBm is suitable for the
device.
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
8
February 22, 2016 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • 203199E