SKY13498-21 Datasheet, PDF (15/21 Pages) Skyworks Solutions Inc. – 0.7 to 2.7 GHz SP10T MIPI Antenna Switch Module

DATA SHEET • SKY13498-21: SP10T ANTENNA SWITCH WITH MIPI INTERFACE
Table 13. Register Description and Programming (3 of 3)
Register
Name
Address
(Hex)
Parameter
Description
Default
(Binary)
MANUFACTURER_ID 001E MANUFACTURER_ID
Bits[7:0]:
10100101
Read–only register
Reserved
Bits[7:6]:
00
Reserved
MANUFACTURER_ID
Bits[5:4]:
01
MAN_USID
001F
Read–only register
USID
Bits[3:0]:
1011
Programmable USID. A write to these bits programs the USID.
Note 1: Unlike the complete independence between triggers 0, 1, and 2, and also between the associated trigger masks 0, 1, and 2, respectively, as described in the MIPI RFFE Specification,
this device uses additional interactions between the provided trigger functions.
The delayed application of updated data to all triggerable registers in this device may be accomplished using any of the three triggers (0, 1, or 2), provided that the particular trigger
used is not currently masked off. If multiple triggers are enabled, any or all of those are sufficient to cause the data to be transferred from shadow registers to destination registers for
all triggerable registers in the device.
It is also necessary to disable all three triggers (i.e., set all three trigger masks) to ensure that data written to any triggerable register will immediately be written to the destination
register at the conclusion of the RFFE command sequence where the data is written.
Evaluation Board Description
The SKY13498-21 Evaluation Board is used to test the
performance of the SKY13498-21 SP10T Switch. An Evaluation
Board schematic diagram is provided in Figure 7. A
recommended ESD protection circuit diagram is provided in
Figure 8. An assembly drawing for the Evaluation Board is shown
in Figure 9.
Package Dimensions
The PCB layout footprint for the SKY13498-21 is provided in
Figure 10. Typical case markings are shown in Figure 11.
Package dimensions for the 20-pin MCM are shown in Figure 12,
and tape and reel dimensions are provided in Figure 13.
Package and Handling Information
Since the device package is sensitive to moisture absorption, it is
baked and vacuum packed before shipping. Instructions on the
shipping container label regarding exposure to moisture after the
container seal is broken must be followed. Otherwise, problems
related to moisture absorption may occur when the part is
subjected to high temperature during solder assembly.
The SKY13498-21 is rated to Moisture Sensitivity Level 3 (MSL3)
at 260 C. It can be used for lead or lead–free soldering. For
additional information, refer to the Skyworks Application Note,
PCB Design and SMT Assembly/Rework Guidelines for MCM–L
Packages, document number 101752.
Care must be taken when attaching this product, whether it is
done manually or in a production solder reflow environment.
Production quantities of this product are shipped in a standard
tape and reel format.
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
202807E • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • April 23, 2014
15