SKY16602-632LF Datasheet, PDF (10/11 Pages) Skyworks Solutions Inc. – Low limiting threshold

DATA SHEET ● SKY16602-632LF: LOW-THRESHOLD PIN DIODE LIMITER
A
2.3
Pin 1
Indicator
C
0.02 +0.03
–0.02
0.726 ±0.05
Exposed Pads
0.255
Detail A
Pin 1 Indicator
(R0.2)
2X 0.20 Min
2.3
1.791 ± 0.05
1 ± 0.05
2X 0.05 C
2X ^{0.05 C}
Top View
B
0.55 ± 0.05
0.05 C
0.05 C
2X ₂
0.255
0.254
0.736 ±0.05
2X 0.478
Side View
Bottom View
Notes:
1. Dimensions and tolerances according to ASME Y14.5M-1994.
2. Coplanarity applies to the exposed heat sink slug as well as the terminals.
3. Dimension applies to metallized terminal. If the terminal has a radius on its end,
the width dimension should not be measured in that area.
4. Plating requirement per source control drawing (SCD) 2504.
5. All measurements are in millimeters.
3
0.10 C A B
0.05 C
Detail A
Scale: 80X
1X This Rotation
1X Rotated 180°
Figure 15. SKY16602-632LF Package Dimensions
0.25 ± 0.05
0.4 ± 0.05
202945E-015
0.25 ± 0.05
2.00 ± 0.05 (See Note 3)
4.00 (See Note 1)
∅1.50 +0.1
–0
4.00
∅1.00 Min.
B
B
Pin 1 Indicator
1.75 ± 0.10
A
R 0.10 Max.
Bo
3.50 ± 0.05
(See Note 3)
8.0 +0.3
–0.1
Ko
Ao
A
Notes:
1. 10 sprocket hole pitch cumulative tolerance ±0.20 mm.
2. ESD surface resistivity shall be < 1 x 10¹⁰ Ohms/Square
per EIA, JEDEC TNR specification.
3. Pocket position relative to sprocket hole measured
as true position of pocket.
4. Ao and Bo are measured on a plane 0.30 mm
above the bottom of the pocket.
5. Carrier tape: black conductive polycarbonate.
6. Cover tape material: transparent conductive material.
7. All measurements are in millimeters.
R 0.1 Typ.
Ao = 2.60 ± 0.05
Bo = 2.60 ± 0.05
Ko = 0.65 ± 0.05
R 0.25 Max.
B
Figure 16. SKY16602-632LF Tape and Reel Dimensions
A
0 ± 0.04 Bridge Height
202945E-016
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
10
April 11, 2016 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • 202945F