|
SI88X2X Datasheet, PDF (9/45 Pages) Silicon Laboratories – Isolation of up to 5000 Vrms | |||
|
◁ |
Si88x2x
Table 2. Electrical Characteristics1 (Continued)
VIN = 24 V; VDDA = VDDP = 3.0 to 5.5 V (see Figure 2) for all Si8822x/32x; VDDA = 4.3 V (see Figure 3) for all Si8842x/62x;
TA = â40 to 125 °C unless otherwise noted.
Parameter
Symbol
Test Condition
Min Typ Max Unit
DC, VDDB = 5 V ± 10%
Si88x20
VDDA
VDDB
VDDA
VDDB
mA
All inputs = 0
â
8.9
All inputs = 0
â
5.3
All inputs = 1
â
5.3
All inputs = 1
â
5.2
Si88x21
VDDA
VDDB
VDDA
VDDB
mA
All inputs = 0
â
7.8
All inputs = 0
â
5.0
All inputs = 1
â
5.9
All inputs = 1
â
3.1
Si88x22
VDDA
VDDB
VDDA
VDDB
mA
All inputs = 0
â
5.8
All inputs = 0
â
6.4
All inputs = 1
â
5.7
All inputs = 1
â
2.7
1 Mbps, VDDB = 5 V ± 10% (All Inputs = 500 kHz Square Wave, CLOAD = 15 pF)
Si88x20
VDDA
VDDB
mA
â
7.1
â
5.3
Si88x21
VDDA
VDDB
mA
â
6.9
â
4.1
Si88x22
VDDA
VDDB
mA
â
5.9
â
4.6
Notes:
1. Over recommended operating conditions as noted in Table 1.
2. VOUT = VSNS x (1 + R1/R2) + R1 x Ioffset
3. VDDP current needed for dc-dc circuits.
4. VDDA current needed for dc-dc circuits.
5. The nominal output impedance of an isolator driver channel is approximately 50 ï, ±40%, which is a combination of
the value of the on-chip series termination resistor and channel resistance of the output driver FET. When driving loads
where transmission line effects will be a factor, output pins should be appropriately terminated with controlled
impedance PCB traces.
6. tPSK(P-P) is the magnitude of the difference in propagation delay times measured between different units operating at
the same supply voltages, load, and ambient temperature.
7. Start-up time is the time period from when the UVLO threshold is exceeded to valid data at the output.
Rev. 0.5
9
|
▷ |