EFM32G280 Datasheet, PDF (55/72 Pages) Silicon Laboratories – Wake-up Interrupt Controller

Table 4.3. GPIO Pinout
...the world's most energy friendly microcontrollers
Port
Port A
Port B
Port C
Port D
Port E
Port F
Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin Pin
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
0
PA15 PA14 PA13 PA12 PA11 PA10 PA9 PA8 PA7 PA6 PA5 PA4 PA3 PA2 PA1 PA0
- PB14 PB13 PB12 PB11 PB10 PB9 PB8 PB7 PB6 PB5 PB4 PB3 PB2 PB1 PB0
PC15 PC14 PC13 PC12 PC11 PC10 PC9 PC8 PC7 PC6 PC5 PC4 PC3 PC2 PC1 PC0
-
-
- PD12 PD11 PD10 PD9 PD8 PD7 PD6 PD5 PD4 PD3 PD2 PD1 PD0
PE15 PE14 PE13 PE12 PE11 PE10 PE9 PE8 PE7 PE6 PE5 PE4 PE3 PE2 PE1 PE0
-
-
-
-
-
-
PF9 PF8 PF7 PF6 PF5 PF4 PF3 PF2 PF1 PF0
4.4 LQFP100 Package
Figure 4.2. LQFP100
Note:
1. Datum 'T', 'U' and 'Z' to be determined at datum plane 'H'.
2. Datum 'D' and 'E' to be determined at seating plane datum 'Y'.
3. Dimension 'D1' and 'E1' do not include mold protrusions. Allowable protrusion is 0.25 per side. Di-
mensions 'D1' and 'E1' do include mold mismatch and are determined at datum plane datum 'H'.
4. Dimension 'b' does not include dambar protrusion. Allowable dambar protrusion shall not cause the
lead width to exceed the maximum 'b' dimension by more than 0.08 mm. Dambar can not be located
on the lower radius or the foot. Minimum space between protrusion and an adjacent lead is 0.07 mm
5. Exact shape of each corner is optional.
2015-05-22 - EFM32G280FXX - d0006_Rev1.90
55
www.silabs.com