EFM32HG350 Datasheet, PDF (54/69 Pages) Silicon Laboratories – Output state retention and wake-up from Shutoff Mode

CSP36 Pin#
and Name
Preliminary
...the world's most energy friendly microcontrollers
Pin Alternate Functionality / Description
Pin Name
Analog
Timers
Communication
Other
To apply an external reset source to this pin, it is required to only drive this pin low during reset, and let the internal pull-up
ensure that reset is released.
E6
PB7
LFXTAL_P
TIM1_CC0 #3
US0_TX #4
US1_CLK #0
F1
PD5
ADC0_CH5
LEU0_RX #0
F2
PB14
HFXTAL_N
US0_CS #4/5
LEU0_RX #1
F3
PB13
HFXTAL_P
US0_CLK #4/5
LEU0_TX #1
F4
AVDD_1
Analog power supply 1.
F5
PB11
IDAC0_OUT
TIM1_CC2 #3
PCNT0_S1IN #4
US1_CLK #4
CMU_CLK1 #3
ACMP0_O #3
F6
PB8
LFXTAL_N
TIM1_CC1 #3
US0_RX #4
US1_CS #0
4.2 Alternate Functionality Pinout
A wide selection of alternate functionality is available for multiplexing to various pins. This is shown in
Table 4.2 (p. 54) . The table shows the name of the alternate functionality in the first column, followed
by columns showing the possible LOCATION bitfield settings.
Note
Some functionality, such as analog interfaces, do not have alternate settings or a LOCA-
TION bitfield. In these cases, the pinout is shown in the column corresponding to LOCA-
TION 0.
Table 4.2. Alternate functionality overview
Alternate
Functionality
0
ACMP0_CH0
PC0
ACMP0_CH1
PC1
ACMP0_O
PE13
ADC0_CH0
PE12
ADC0_CH1
PE13
ADC0_CH5
PD5
ADC0_CH6
PD6
ADC0_CH7
PD7
BOOT_RX
PF1
BOOT_TX
PF0
CMU_CLK0
PA2
CMU_CLK1
PA1
LOCATION
1
2
3
4
PD6 PB11
PD7 PF2
PE12 PB11
DBG_SWCLK
PF0
DBG_SWDIO
PF1
5
6
Description
Analog comparator ACMP0, channel 0.
Analog comparator ACMP0, channel 1.
Analog comparator ACMP0, digital output.
Analog to digital converter ADC0, input channel number 0.
Analog to digital converter ADC0, input channel number 1.
Analog to digital converter ADC0, input channel number 5.
Analog to digital converter ADC0, input channel number 6.
Analog to digital converter ADC0, input channel number 7.
Bootloader RX.
Bootloader TX.
Clock Management Unit, clock output number 0.
Clock Management Unit, clock output number 1.
Debug-interface Serial Wire clock input.
Note that this function is enabled to pin out of reset, and
has a built-in pull down.
Debug-interface Serial Wire data input / output.
2015-05-06 - EFM32HG350FXX - _Rev0.91
54
www.silabs.com