SI1000-E-GM2 Datasheet, PDF (360/382 Pages) Silicon Laboratories – MCU with Integrated 240–960 MHz EZRadioPRO® Transceiver

Si1000/1/2/3/4/5
28.3. Capture/Compare Modules
Each module can be configured to operate independently in one of six operation modes: edge-triggered
capture, software timer, high speed output, frequency output, 8 to 11-bit pulse width modulator, or 16-bit
pulse width modulator. Each module has Special Function Registers (SFRs) associated with it in the CIP-
51 system controller. These registers are used to exchange data with a module and configure the module's
mode of operation. Table 28.2 summarizes the bit settings in the PCA0CPMn and PCA0PWM registers
used to select the PCA capture/compare module’s operating mode. Note that all modules set to use 8, 9,
10, or 11-bit PWM mode must use the same cycle length (8-11 bits). Setting the ECCFn bit in a
PCA0CPMn register enables the module's CCFn interrupt.
Table 28.2. PCA0CPM and PCA0PWM Bit Settings for PCA Capture/Compare Modules
Operational Mode
Bit Number
Capture triggered by positive edge on CEXn
Capture triggered by negative edge on CEXn
Capture triggered by any transition on CEXn
Software Timer
High Speed Output
Frequency Output
8-Bit Pulse Width Modulator (Note 7)
9-Bit Pulse Width Modulator (Note 7)
10-Bit Pulse Width Modulator (Note 7)
11-Bit Pulse Width Modulator (Note 7)
16-Bit Pulse Width Modulator
PCA0CPMn
PCA0PWM
7 6 5 4 3 2 1 0 7 6 5 4-2 1–0
X X 1 0 0 0 0 A 0 X B XXX XX
X X 0 1 0 0 0 A 0 X B XXX XX
X X 1 1 0 0 0 A 0 X B XXX XX
X C 0 0 1 0 0 A 0 X B XXX XX
X C 0 0 1 1 0 A 0 X B XXX XX
X C 0 0 0 1 1 A 0 X B XXX XX
0 C 0 0 E 0 1 A 0 X B XXX 00
0 C 0 0 E 0 1 A D X B XXX 01
0 C 0 0 E 0 1 A D X B XXX 10
0 C 0 0 E 0 1 A D X B XXX 11
1 C 0 0 E 0 1 A 0 X B XXX XX
Notes:
1. X = Don’t Care (no functional difference for individual module if 1 or 0).
2. A = Enable interrupts for this module (PCA interrupt triggered on CCFn set to 1).
3. B = Enable 8th, 9th, 10th or 11th bit overflow interrupt (Depends on setting of CLSEL[1:0]).
4. C = When set to 0, the digital comparator is off. For high speed and frequency output modes, the
associated pin will not toggle. In any of the PWM modes, this generates a 0% duty cycle (output = 0).
5. D = Selects whether the Capture/Compare register (0) or the Auto-Reload register (1) for the associated
channel is accessed via addresses PCA0CPHn and PCA0CPLn.
6. E = When set, a match event will cause the CCFn flag for the associated channel to be set.
7. All modules set to 8, 9, 10 or 11-bit PWM mode use the same cycle length setting.
360
Rev. 1.3