SI8441AB-D-IS Datasheet, PDF (25/38 Pages) Silicon Laboratories – LOW-POWER QUAD-CHANNEL DIGITAL ISOLATOR

Si8440/41/42/45
3. Errata and Design Migration Guidelines
The following errata apply to Revision C devices only. See "5. Ordering Guide" on page 27 for more details. No
errata exist for Revision D devices.
3.1. Enable Pin Causes Outputs to Go Low (Revision C Only)
When using the enable pin (EN1, EN2) function on the 4-channel (Si8440/1/2) isolators, the corresponding output
pin states (pin = An, Bn, where n can be 1…4) are driven to a logic low (to ground) when the enable pin is disabled
(EN1 or EN2 = 0). This functionality is different from the legacy 4-channel (Si8440/1/2) isolators. On those devices,
the isolator outputs go into a high-impedance state (Hi-Z) when the enable pin is disabled (EN1 = 0 or EN2 = 0).
3.1.1. Resolution
The enable pin functionality causing the outputs to go low is supported in production for Revision C of the Si844x
devices. Revision D corrects the enable pin functionality (i.e., the outputs will go into the high-impedance state to
match the legacy isolator products). Refer to the Ordering Guide sections of the data sheet(s) for current ordering
information.
3.2. Power Supply Bypass Capacitors (Revision C and Revision D)
When using the Si844x isolators with power supplies > 4.5 V, sufficient VDD bypass capacitors must be present on
both the VDD1 and VDD2 pins to ensure the VDD rise time is less than 0.5 V/µs (which is > 9 µs for a > 4.5 V
supply). Although rise time is power supply dependent, > 1 µF capacitors are required on both power supply pins
(VDD1, VDD2) of the isolator device.
3.2.1. Resolution
For recommendations on resolving this issue, see "2.4.1. Supply Bypass" on page 22. Additionally, refer to "5.
Ordering Guide" on page 27 for current ordering information.
3.3. Latch Up Immunity (Revision C Only)
Latch up immunity generally exceeds ± 200 mA per pin. Exceptions: Certain pins provide < 100 mA of latch-up
immunity. To increase latch-up immunity on these pins, 100  of equivalent resistance must be included in series
with all of the pins listed in Table 14. The 100  equivalent resistance can be comprised of the source driver's
output resistance and a series termination resistor. The Si8441 is not affected when using power supply voltages
(VDD1 and VDD2) < 3.5 V.
3.3.1. Resolution
This issue has been corrected with Revision D of the device. Refer to “5. Ordering Guide” for current ordering
information.
Table 14. Affected Ordering Part Numbers (Revision C Only)
Affected Ordering Part Numbers*
SI8440SV-C-IS/IS1, SI8441SV-C-IS/IS1,
SI8442SV-C-IS/IS1
Device
Revision
C
SI8445SV-C-IS/IS1
C
*Note: SV = Speed Grade/Isolation Rating (AA, AB, BA, BB).
Pin#
6
10
14
6
14
Name
A4
EN2
B1
A4
B1
Pin Type
Input or Output
Input
Output
Input
Output
Rev. 1.5
25