S-24CM01C Datasheet, PDF (9/32 Pages) Seiko Instruments Inc – Write protect function during the low power supply voltage

Rev.2.0_02_S
2-WIRE SERIAL E²PROM
S-24CM01C
 ECC Function (Error correction function)
S-24CM01C Series adds 6 ECC bits for error correction to each 4 bytes with the same address of P0, W15 to W2. The
ECC function can make correction and output correct data even if wrong data of 1 bit is in the 4 bytes when reading.
In addition, the S-24CM01C Series rewrites the 4 bytes used as the rewriting minimum unit and 6 ECC bits if only 1 byte
data is input.
Therefore, it is recommended to rewrite data of each 4 bytes with the same address of P0, W15 to W2 in order to get the
maximum endurance in the application in which the data is rewritten frequently.
 Operation
1. Start condition
Start is identified by a high to low transition of the SDA line while the SCL line is stable at high.
Every operation begins from a start condition.
2. Stop condition
Stop is identified by a low to high transition of the SDA line while the SCL line is stable at high.
When a device receives a stop condition during a read sequence, the read operation is interrupted, and the device
enters standby mode.
When a device receives a stop condition during a write sequence, the reception of the write data is halted, and the S-
24CM01C initiates a write cycle.
t_SU.STA t_HD.STA
t_SU.STO
SCL
SDA
Start Condition
Figure 7 Start / Stop Conditions
Stop Condition
9