S-8211C Datasheet, PDF (26/41 Pages) Seiko Instruments Inc – BATTERY PROTECTION IC FOR 1-CELL PACK

BATTERY PROTECTION IC FOR 1-CELL PACK
S-8211C Series
Rev.5.0_00
„ Battery Protection IC Connection Example
EB+
R1
VDD
Battery C1
S-8211C Series
VSS
DO
CO
VM
R2
FET1 FET2
EB−
Figure 14
Table 17 Constants for External Components
Symbol Part
Purpose
Typ.
Min.
Max.
Remark
FET1
N-channel
MOS FET
Discharge control
Threshold voltage ≤ Overdischarge
−
−
−
detection voltage ^*1
Gate to source withstanding voltage ≥
Charger voltage ^*2
FET2
N-channel _{Charge control}
MOS FET
Threshold voltage ≤ Overdischarge
−
−
−
detection voltage ^*1
Gate to source withstanding voltage ≥
Charger voltage ^*2
Resistance should be as small as
R1
ESD protection,
Resistor _{For power fluctuation}
220 Ω
100 Ω
330 Ω
possible to avoid lowering the
overcharge detection accuracy due to
current consumption. ^*3
C1
Capacitor For power fluctuation
0.1 µF
0.022 µF
1.0 µF
Connect a capacitor of 0.022 µF or
higher between VDD pin and VSS pin. ^*4
Protection for reverse
Select as large a resistance as possible
R2
Resistor connection of a
charger
2 kΩ
300 Ω
2 kΩ
to prevent current when a charger is
connected in reverse. ^*5
*1. If the threshold voltage of an FET is low, the FET may not cut the charging current. If an FET with a threshold voltage
equal to or higher than the overdischarge detection voltage is used, discharging may be stopped before overdischarge
is detected.
*2. If the withstanding voltage between the gate and source is lower than the charger voltage, the FET may be destroyed.
*3. If R1 has a high resistance, the voltage between VDD pin and VSS pin may exceed the absolute maximum rating when
a charger is connected in reverse since the current flows from the charger to the IC. Insert a resistor of 100 Ω or higher
as R1 for ESD protection.
*4. If a capacitor of less than 0.022 µF is connected to C1, DO pin may oscillate when load short-circuiting is detected. Be
sure to connect a capacitor of 0.022 µF or higher to C1.
*5. If R2 has a resistance higher than 2 kΩ, the charging current may not be cut when a high-voltage charger is connected.
Caution 1. The above constants may be changed without notice.
2. It has not been confirmed whether the operation is normal or not in circuits other than the above
example of connection. In addition, the example of connection shown above and the constant do not
guarantee proper operation. Perform thorough evaluation using the actual application to set the
constant.
26
Seiko Instruments Inc.