S-19103N10H-M5T1U Datasheet, PDF (17/34 Pages) Seiko Instruments Inc – VOLTAGE DETECTOR WITH SENSE PIN

FOR AUTOMOTIVE 105°C OPERATION VOLTAGE DETECTOR WITH SENSE PIN
Rev.1.2_01
S-19103/19109 Series
1. 2 S-19103/19109 Series C type
(1) When the power supply voltage (V_DD) is the minimum operation voltage or higher, and the SENSE pin voltage
(V_SENSE) is the release voltage (+V_DET) or higher, the Nch transistor is turned off and the Pch transistor is turned
on to output V_DD ("H").
At this time, the input voltage to the comparator is
(R_B +
R_A
R_C ) • V_SENSE
+ R_B + R_C
.
(2) When V_SENSE decreases to −V_DET or lower (point A in Figure 22), the Nch transistor is turned on and the Pch
transistor is turned off. And then V_SS ("L") is output from the OUT pin after the elapse of the detection delay time
(t_DET).
(3) Even if V_SENSE further decreases to the IC's minimum operation voltage or lower, the output from the OUT pin is
stable when V_DD is minimum operation voltage or higher.
(4) Even if V_SENSE increases, V_SS is output when V_SENSE is lower than +V_DET.
(5) When V_SENSE increases to +V_DET or higher (point B in Figure 22), the Nch transistor is turned off and the Pch
transistor is turned on. And then V_DD is output from the OUT pin after the elapse of the release delay time
(t_RESET).
VDD
SENSE
V_DD
V_SENSE
VSS
R_A
+
*1
*1
−
R_B
V_REF
R_C
Pch
*1
OUT
*1
Nch
+
V
*1. Parasitic diode
Figure 21 Operation of S-19103/19109 Series C Type
(1) (2) (3) (4) (5)
Detection voltage (−VDET)
A
B
Release voltage (+VDET)
V_SENSE
Minimum operation voltage
V_SS
Output from OUT pin
t_DET
t_RESET
V_DD
V_SS
Remark The release voltage is set to the same value as the detection voltage, since there is no hysteresis width.
Figure 22 Timing Chart of S-19103/19109 Series C Type
17