S-19103N10H-M5T1U Datasheet, PDF (15/34 Pages) Seiko Instruments Inc – VOLTAGE DETECTOR WITH SENSE PIN

FOR AUTOMOTIVE 105°C OPERATION VOLTAGE DETECTOR WITH SENSE PIN
Rev.1.2_01
S-19103/19109 Series
3. Feed-through current
The feed-through current is a current that flows instantaneously to the VDD pin at the time of detection and release
of a voltage detector. The feed-through current is large in CMOS output product, small in Nch open-drain output
product.
4. Oscillation
In applications where an input resistor is connected (Figure 18), taking a CMOS output (active "L") product for
example, the feed-through current which is generated when the output goes from "L" to "H" (at the time of release)
causes a voltage drop equal to [feed-through current] × [input resistance]. Since the VDD pin and the SENSE pin
are shorted as in Figure 18, the SENSE pin voltage drops at the time of release. Then the SENSE pin voltage
drops below the detection voltage and the output goes from "H" to "L". In this status, the feed-through current stops
and its resultant voltage drop disappears, and the output goes from "L" to "H". The feed-through current is then
generated again, a voltage drop appears, and repeating the process finally induces oscillation.
V_DD
R_A
V_IN
R_B
VDD
SENSE ^OUT
VSS
(CMOS output product)
GND
Figure 18 Example for Bad Implementation Due to Detection Voltage Change
Caution
The release voltage is set to the same value as the detection voltage, since there is no hysteresis
width in the S-19103/19109 Series. Therefore, the output goes from "H" to "L" if the power
supply voltage (V_DD) reaches the detection voltage. The voltage which once became to "L" goes
from "L" to "H" again. This repeating process may induce oscillation as well. Perform thorough
evaluation using the actual application.
15