S-11L10 Datasheet, PDF (11/35 Pages) Seiko Instruments Inc – SUPER-LOW OUTPUT LOW DROPOUT CMOS VOLTAGE REGULATOR

SUPER-LOW OUTPUT VOLTAGE LOW DROPOUT CMOS VOLTAGE REGULATOR
Rev.1.0_00
S-11L10 Series
„ Standard Circuit
Input
C_IN^*1
VIN
VOUT
ON / OFF
VSS
Output
C_L^*2
Single GND
GND
*1. C_IN is a capacitor for stabilizing the input.
*2. Ceramic capacitor of 1.0 µF or more can be used as C_L.
Figure 11
Caution The above connection diagram and constant will not guarantee successful operation. Perform
thorough evaluation using the actual application to set the constant.
„ Condition of Application
Input capacitor (C_IN) : 1.0 µF or more
Output capacitor (C_L) : 1.0 µF or more (ceramic capacitor)
Caution A general series regulator may oscillate, depending on the external components. Confirm that no
oscillation occurs in the application for which the above capacitors are used.
„ Selection of Input and Output Capacitors (C_IN, C_L)
The S-11L10 Series requires an output capacitor between the VOUT and VSS pin for phase compensation. Operation is
stabilized by a ceramic capacitor with an output capacitance of 1.0 µF or more over the entire temperature range.
When using an OS capacitor, tantalum capacitor, or aluminum electrolytic capacitor, the capacitance must be 1.0 µF or
more.
The value of the output overshoot or undershoot transient response varies depending on the value of the output
capacitor. The required capacitance of the input capacitor differs depending on the application.
The recommended capacitance for an application is C_IN ≥ 1.0 µF, C_L ≥ 1.0 µF; however, when selecting the output
capacitor, perform sufficient evaluation, including evaluation of temperature characteristics, on the actual device.
Seiko Instruments Inc.
11