LQ0B152 Datasheet, PDF (4/7 Pages) Sharp Electrionic Components – DEVICE SPECIFICATION FOR BACKLIGHT UNIT

SHARP
(7) Environmental condition
7- 1) Operating temperature range ^{0 c1+50 “C}
7-2) Storage temperature range -25 - +60 “C
LD8706- 3
(8) Procedure to exchange backlight unit
Fig. 2 shows the procedure to exchange backlight unit.
Please follow the below instructions to exchange the backlight unit for
TFT-LCD module .
* When handling the module , please be careful not to scratch on the LCD panel
surface or not to make it dirty.
8- 1) Work this exchange putting the module( 1) rear side on the top and locate the
inverter portion at the worker side. Disconnect 2 connectors between the
lamp(A) and the inverter(B).
Please be careful not to pull out the lead wire.
8-2) The latch for the holder can be loosened by pulling out and slightly twisting the
holders. The twist direction is clockwise for the right side holder (bottom side)
and counterclockwise for the left side holder (top side).
Please draw the lamp holder slowly and not to pull out the lead wire.
8-3) Insert the new lamp holder(2) into the backlight slot slowly and fix the holder
latching to the hooking portion.
Please be careful not to put foreign articles into the holder.
84)Connect 2 connectors between the lamp and the inverter.
(9) Packing form
Packing form is shown in Fig. 3.
(10) Others
If any problem occurs in relation to the description in the present
specifications or other relevant items, it shail be eliminated in all
sincerity through discussion.