LQ0B152 Datasheet, PDF (2/7 Pages) Sharp Electrionic Components – DEVICE SPECIFICATION FOR BACKLIGHT UNIT

SHARP
LD8706- 1
(1) Subject
LQOB 152 : Literature on backlight unit for 35cm( 13.8”) TFI’-LCD module.
> These specification sheets are the proprietary product of SHARP CORPORATION
(SHARP) and include materials protected under copyright of SHARP. Do not
reproduce or cause any third party to reproduce them in any form or by any means,
electronic or mechanical, for any purpose, in whole or in part, without the express
written permission of SHARP.
> The device listed in these specification sheets was designed and manufactured for use
in OA equipment.
> In case of using the device for applications such as control and safety equipment for
transportation (aircraft, trains, automobiles, etc. ), rescue and security equipment and
various safety related equipment which require higher reliability and safety, take into
consideration that appropriate measures such as fail-safe functions and redundant
system design should be taken.
> Do not use the device for equipment that requires an extreme level of reliability, such
as aerospace applications, telecommunication equipment(trunk lines), nuclear power
control equipment and medical or other equipment for life support.
> SHARP assumes no responsibility for any damage resulting from the use of the
device which does not comply with the instructions and the precautions specified in
these specification sheets.
Contact and consult with a SHARP sales representative for any questions about this
device.
(2) Introduction
This backlight unit is a service part for 35cm TFT-LCD module (LQ14XOl)
whose backlight is designed to be replaceable.
(3) Construction and Outline
The unit is composed of cold cathode fluorescent tubes, rubber cushions,
I/O wires (including connectors), and lamp holders.
* Outline drawing of backlight unit : See Fig. 1.