LQ14D412 Datasheet, PDF (17/19 Pages) Sharp Electrionic Components – TENRI LIQUID CRYSTAL DISPLAY GROUP SHARP CORPORATION SPECIFICATION

.
LD-7606-15
10. Display Quantity
The display quality of the color TFI’-LCD module shall be in compliance with the
Tncoming Inspection Standard.
11. Handling Precautions
a) Be sure to turn off the power supply when inserting or discomecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as
warp or twist.
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water &op immediately, Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
O Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
Handle with care.
g) Since CMOS LSI is used in this module, take care of static electricity and touch the ground
through yourself when handling.
h) Obse~e all other precautionary requirements in handling components.
i) This module has its circuitry PCBS on the rear side and should be carefully handled in order not
to be stressed.
j) Laminated film is attached to the module surface to prevent it from being scratched . Peel the
fti off slowly, just before the use, with strict attention to electrostatic charges. Ionized air shall
.“ .
be blown over during the action. Blow off ‘dust’ on the polarizer by using an ionized nitrogen gun,
etc.
12. Packing form
a) Piling number of cartons : MAX.6
b) Package quantity in one carton: 10pcs
c) Carton size : 370(W) X 470(H) X 590(D)mm
d) Total mass of 1 carton filled with full modules: 18,000g
Packing form is shown in Fig.4