LC895125Q Datasheet, PDF (7/11 Pages) Sanyo Semicon Device – CD-ROM Driver with On-Chip SCSI Interface and Subcode Functions

LC895125Q, 895125W
Pin Functions (LC895125W)
Type: I: Input pin, O: Output pin, B: Bidirectional pin, P: Power supply pin, NC: No connection pin
Pin No.
Symbol
Type
Function
1
V_SS0
P
2
V_DD
P
3
V_SS0
P
4
RA5
O
5
RA6
O
Buffer RAM address signal outputs
6
RA7
O
7
RA8
O
8
RA9 (IO15)
B _{Address outputs for the buffer RAM or data I/O pins}
9
RA10 (IO14)
B ^{The pin circuits include pull-up resistors.}
10
V_SS0
P
11
RA11 (IO13)
B
12
RA12 (IO12)
B
13
RA13 (IO11)
B _{Address outputs for the buffer RAM or data I/O pins}
14
RA14 (IO10)
B ^{The pin circuits include pull-up resistors.}
15
RA15 (IO9)
B
16
RA16 (IO8)
B
17
IO7
B Buffer RAM data I/O. The pin circuit includes a pull-up resistor.
18
V_DD
P
19
V_SS0
P
20
NC
21
IO6
B
22
IO5
B
23
IO4
B
24
IO3
B
Buffer RAM data I/O.
The pin circuit includes a pull-up resistor.
25
IO2
B
26
IO1
B
27
IO0
B
28
V_SS0
P
29
TEST0
I
30
TEST1
I
31
TEST2
I Test pins. These pins must be connected to V_SS0.
32
TEST3
I
33
TEST4
I
34
ZRESET
I LSI reset. The LSI is reset on a 0 input.
35
V_DD
P
36
V_SS0
P
37
V_DD
P
38
V_SS0
P
39
CSCTRL
I Selects active-high or active-low for the microcontroller CS logic.
40
XTALCK0
I Crystal oscillator input
41
XTAL0
O Crystal oscillator output
42
V_SS0
P
43
D0
B
44
D1
B
45
D2
B
46
D3
B
Microcontroller data signals
47
D4
B
48
D5
B
49
D6
B
50
D7
B
Note: 1. NC pins must be left open. Do not connect any signal to these pins.
2. Pin names that start with Z are negative-logic signals.
3. V_SS0 is the logic system ground and V_SS1 is the SCSI interface ground.
4. Applications that use DRAM must insert resistors in the CAS and RAS lines, connect capacitors between these lines and ground, and take any
other measures necessary to prevent undershoot in the DRAM related circuits.
5. Since these circuits include buffers that sink 48 mA, adequate noise prevention measures must be applied.
Continued on next page.
No. 5241-7/11