English
Language : 

LC895125Q Datasheet, PDF (6/11 Pages) Sanyo Semicon Device – CD-ROM Driver with On-Chip SCSI Interface and Subcode Functions
LC895125Q, 895125W
Continued from preceding page.
Type: I: Input pin, O: Output pin, B: Bidirectional pin, P: Power supply pin, NC: No connection pin
Pin No.
Symbol
Type
Function
101
VSS0
P
102
NC
103
NC
104
C2PO
I
105
SDATA
I
CD DSP interface
106
BCK
I
107
LRCK
I
108
MCK
O Outputs the XTALCK0 frequency, or that frequency divided by 2.
109
VSS0
P
110
EXCK
O
111
WFCK
I Subcode I/O
112
SBSO
I
113
VDD
P
114
SCOR
I Subcode I/O
115
VSS0
P
116
ZRAS0
O Buffer RAM RAS signal output pin 0 (Normally, pin 0 is used)
117
ZRAS1
O Buffer RAM RAS signal output pin 1
118
ZCAS0
O Buffer RAM CAS signal output pin 0 (Normally, pin 0 is used)
119
ZCAS1
O Buffer RAM CAS signal output pin 1
120
ZOE
O Buffer RAM output enable
121
ZUWE
O Buffer RAM upper write enable
122
ZLWE
O Buffer RAM lower write enable
123
VSS0
P
124
RA0
O
125
RA1
O
126
RA2
O Buffer RAM address signal outputs
127
RA3
O
128
RA4
O
Note: 1. NC pins must be left open. Do not connect any signal to these pins.
2. Pin names that start with Z are negative-logic signals.
3. VSS0 is the logic system ground and VSS1 is the SCSI interface ground.
4. Applications that use DRAM must insert resistors in the CAS and RAS lines, connect capacitors between these lines and ground, and take any
other measures necessary to prevent undershoot in the DRAM related circuits.
5. Since these circuits include buffers that sink 48 mA, adequate noise prevention measures must be applied.
No. 5241-6/11