LC875032A Datasheet, PDF (4/25 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with 32/24/16K-Byte EPROM and 640-Byte RAM On Chip

LC875032A/24A/16A
- X’tal HOLD mode
X’tal HOLD mode is used to reduce power consumption. Program execution is stopped. All peripheral circuits
except the base timer are stopped.
1. CF and RC oscillation circuits stop automatically
2. Crystal oscillator is maintained in its state at HOLD mode inception.
3. Release occurs on any of the following conditions
•input to the reset pin goes low
•a specified level is input to at least one of INT0, INT1, INT2, INT4, INT5
•an interrupt condition arises at port 0
•an interrupt condition arises at the base-timer
(18) Factory shipment
- delivery form QIP64E
- delivery form DIP64S
(19) Development Tools
- Evaluation chip
- Emulator
: LC876098
: EVA87000 + ECB875000 (Evaluation chip board) + POD875000 (POD)
No.6713-4/25