QTE Datasheet, PDF (2/8 Pages) Samtec, Inc – 0,80 mm (.0315”) Q Strip® High Speed Ground Plane Socket / Terminal Strips

Product Specification
Series: QSE / QTE 0,80 mm (.0315”) Q Strip^® High Speed Ground Plane Socket / Terminal Strips
1.0 SCOPE
1.1 This specification covers performance, testing and quality requirements for Samtec QSE/QTE Series 0,80 mm
(.0315”) Q Strip^® High Speed Socket/Terminal Strip connector system. These socket and terminal strips are
available in Vertical and Edge Mount configurations for parallel, perpendicular and co-planar board-to-board
applications. All information contained in this specification is for a 5 mm mated height vertical configuration unless
otherwise noted.
2.0 DETAILED INFORMATION
2.1 Product prints, footprints, catalog pages, test reports and other specific, detailed information can be found at
www.samtec.com?QSE and www.samtec.com?QTE.
3.0 TESTING
3.1 Current Rating: Signal: 2A (One Pin Powered Per Row); Ground: 11.6A (One Pin Powered Per Row)
3.2 Voltage Rating: 225 VAC
3.3 Operating Temperature Range: -55°C to +125°C
3.4 Operating Humidity Range: 90% to 95% (Per EIA-364-31)
3.5 Electrical:
ITEM
Withstanding Voltage
Insulation Resistance
Contact Resistance
(LLCR)
3.6 Mechanical:
TEST CONDITION
EIA-364-20 (No Flashover,
Sparkover, or Breakdown)
EIA-364-21 (1000 MΩ
minimum)
EIA-364-23
REQUIREMENT
675 VAC
5,000 MΩ
Δ 15 mΩ maximum
(Samtec defined)/ No damage
STATUS
Pass
Pass
Pass
ITEM
Durability
Random Vibration
Mechanical Shock
Normal Force
TEST CONDITION
EIA-364-09C
EIA-364-28 Condition V, Letter B
7.56 G 'RMS', 50 to 2000 Hz, 2
hours per axis, 3 axis total , PSD
0.04
EIA-364-27 100 G, 6
milliseconds, sawtooth wave,
11.3 fps, 3 shocks/direction, 3
axis (18 total shocks)
EIA-364-04
REQUIREMENT
500 cycles (10µ" Au)
Visual Inspection: No Damage
LLCR: Δ 15 mΩ maximum
Event Detection: No interruption >
50 Nanoseconds
Visual Inspection: No Damage
LLCR: Δ 15 mΩ maximum
Event Detection: No interruption >
50 Nanoseconds
30 grams minimum for gold
interface
STATUS
Pass
Pass
Pass
Pass
Revision: C
Date: November 11, 2015
Page 2
© Samtec, Inc.