|
BU7839GVW Datasheet, PDF (8/16 Pages) Rohm – Digital Input Hi-Fi Class-D Headphone Amplifier | |||
|
◁ |
â DC characteristic
Ta=25degree,DVDD=DVDDIO=1.5V, VDD_R=VDD_L=PLLVDD=2.8V
Standardized values
Item
Symbol
MIN
TYP
MAX
Input âHâ Level
0.7x
VIH
DVDDIO
-
-
Input âLâ Level
VIL
-
-
0.3x
DVDDIO
Output âHâ Level
VOH
0.8x
DVDDIO
-
-
Output âLâ Level 1
VOL1
-
-
0.2x
DVDDIO
Output âLâ Level 2
(SDA terminal)
VOL2
-
-
0.2x
DVDDIO
Table 10 DC characteristic
Unit
Note
V
V
V Io=-1mA
V Io=1mA
V Io=3mA
â2wire CPU I/F Part
Device address is "0110011"(33h) or "0110110"(36h), i.e. 33h when ADR terminal is L or 36h when ADR terminal
is H.
Please donât switch the ADR terminal while 2wire CPU I/F is operating.
The transmission rate is compatible with a maximum of 400kbps
2wire CPU I/F device address
ADR A7 A6 A5 A4 A3 A2 A1 W/R
0
0110011
0/1
1
0110110
0/1
â Bit transmission
The data of 1bit is transmitted while SCL is H. In case of bit transmission, the signal transition of SDA can not be
implemented while SCL is H.
If SDA changes while SCL is H, START condition or STOP condition is generated, it is interpreted as control signal.
SDA
SCL
SSDDDAaAstataå®isblå®eeffsç¶etacæ
ttiev:eï¼
ãã¼ã¿æå¹
SDA
SchDanAgå¤e iså
Poå¯ssè½ible
â START condition/STOP condition
Data transmission on bus is not implemented while SDA and SCL are H. At this time, if SCL remains to be H and
SDA is transited from H to L, then the START condition (S) is attained and so the access is started, and if SCL
remains to be H and SDA is transited from L to H, then the STOP condition (P) is attained and so the access is
terminated, which is shown below.
SDA
SCL
S
STSATRATRcToæ¡nd件ition
P
STSOTPOPconæ¡di件tion
This device accepts the continuous START condition and the continuous STOP condition.
8 / 15
|
▷ |