BU24033GW_16 Datasheet, PDF (6/25 Pages) Rohm – u - step System Lens Driver for Digital Still Cameras

BU24033GW
●Description of Blocks
Current Driver (6ch Driver)
Built-in constant current driver.
The voltage of RNF pin and the external resistor (RRNF) determine the amount of output current. The internal
high-precision amplifier (CMOS gate input) is used for constant current control. If any resistance component exists in
the wirings of RNF pin and the external resistor (RRNF), the precision can be reduced. To avoid this, pay utmost
attention to the wirings.
(1) Control
(ⅰ)Register Control
The constant current drive is executed by the output current value, the current direction and the current ON/OFF which
are controlled by the register settings.
Current value _CSB
Direction
SCLK
ON/OFF ₃ SDATA
Host
SIF
Control
Logic
Current control
DAC
C.C.
VCM
(ⅱ)External Pin Control
The constant current drive is executed by the output current value and current direction which are controlled by the
register setting. Constant current driving ON/OFF is controlled by IN6 pin.
CSB
Current value ^SCLK
Direction 3 ^SDATA
SIF
Host
ON/OFF
IN6
Control
Logic
Current control
DAC
C.C.
VCM
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
6/21
TSZ02201-0M3M0BC16060-1-2
20.May.2016 Rev.003