TCFG_C Datasheet, PDF (4/12 Pages) Rohm – Chip tantalum capacitors with (Fail-safe open structure type)

Tantalum capacitors
Item
Performance
Temperature Temp.
Stability
ΔC / C
−55°C
Within 0/−12%of initial value
tanδ
L.C
Temp.
Shall be satisfied the voltage on "Standard list"
−
+85°C
ΔC / C
Within +12/0%of initial value
tanδ
L.C
Temp.
Shall be satisfied the voltage on "Standard list"
5μA or 0.1CV whichever is greater
+125°C
ΔC / C
Within +15/0%of initial value
Surge
Voltage
tanδ
Shall be satisfied the voltage on "Standard list"
L.C
6.3μA or 0.125CV whichever is greater
Appearance There should be no significant abnormality.
L.C
ΔC / C
tanδ
Less than initial value
Within ±12%of initial value
Less than 150% of initial limit
Loading at Appearance
High
temperature ^L.C
ΔC / C
There should be no significant abnormality.
Less than 125% of initial limit
Within ±20%of initial value
tanδ
Less than 150% of initial limit
Terminal Capacitance The measured value should be stable.
Strength _{Appearance There should be no significant abnormality.}
Adhesiveness
The terminal should not come off.
TCFG series C Case
Test conditions
(based on JIS C5101-1 and JIS C5101-3)
As per 4.29 JIS C 5101-1
As per 4.13 JIS C 5101-3
As per 4.26 JIS C 5101-1
As per 4.14 JIS C 5101-3
Apply the specified surge voltage every 5±0.5min.
for 30±5 s. each time in the atmospheric condition
of 85±2°C.
Repeat this procedure 1,000 times.
After the specimens, leave it at room temperature
for over 24h and then measure the sample.
As per 4.23 JIS C 5101-1
As per 4.15 JIS C 5101-3
After applying the rated voltage for 2000+72/0h
without discontinuation via the serial resistance
of 3Ω or less at a temperature of 85±2°C, leave
the sample at room temperature/humidity for
over 24h and measure the value.
As per 4.35 JIS C 5101-1
As per 4.9 JIS C 5101-3
A force is applied to the terminal until it bends
to 1mm and by a prescribed tool maintain the
condition for 5s. (See the figure below.)
20
50
(Unit : mm)
F (Apply force)
R230
1
Thickness 1.6mm
45 45
As per 4.34 JIS C 5101-1
As per 4.8 JIS C 5101-3
Apply force of 5N in the two directions shown
in the figure below for 10±1s after mounting
the terminal on a circuit board.
product
Apply force
a circuit board
Rev.C
4/11