BU9883FV-W Datasheet, PDF (13/19 Pages) Rohm – I2C BUS 3Ports for HDMI Port Serial EEPROM

●Software reset
Software reset is executed when to avoid malfunction after power on, and to reset during command input. Software
reset has several kinds, and 3 kinds of them are shown in the figure below. (Refer to Fig.50(a), Fig.50(b), and Fig.50
(c).) In dummy clock input area, release the SDA0～3 bus ('H' by pull up). In dummy clock area, ACK output and
read data '0' (both 'L' level) may be output from EEPROM, therefore, if 'H' is input forcibly, output may conflict and
over current may flow, leading to instantaneous power failure of system power source or influence upon devices.
Dummy clock×14
Start×2
SCL0～3
12
13 14
Normal command
SDA0～3
Normal command
Fig.50-(a) The case of dummy clock +START+START+ command input
SCL0～3
SDA0～3
Start
1
Dummy clock×9
2
8
Start
9
Normal command
Normal command
Fig.50-(b) The case of START +9 dummy clocks +START+ command input
SCL0～3
SDA0～3
Start×9
1 23
7 89
Normal command
Normal command
Fig.50-(c) START×9+ command input
※ _{Start command from START input.}
●Acknowledge polling
During internal write execution, all input commands are ignored, therefore ACK is not sent back. During internal
automatic write execution after write cycle input, next command (slave address) is sent, and if the first ACK signal
sends back 'L', then it means end of write action, while if it sends back 'H', it means now in writing. By use of
acknowledge polling, next command can be executed without waiting for tWR = 5ms.
When to write continuously, R/W = 0, when to carry out current read cycle after write, slave address R/W = 1 is sent,
and if ACK signal sends back 'L', then execute word address input and data output and so forth.
First write command
During internal write,
ACK = HIGH is sent back.
S
T
A
R
T
S
Write command
T
O
P
S
T Slave
A
R ^address
T
A
C
K
H
S
T _Slave
A
R address
T
A
C
K
H
t_WR
Second write command
…
S
T Slave
A
R
address
T
A
C
K
H
t_WR
S
T Slave
A
R ^address
T
A
C
Word
K
L
address
A
C
K
L
Data
AS
CT
KO
LP
After completion of internal write,
ACK=LOW is sent back, so input next
word address and data in succession.
Fig.51 Case to continuously write by acknowledge polling
13/18