English
Language : 

BD9132MUV_12 Datasheet, PDF (12/20 Pages) Rohm – 2.7V to 5.5V, 3.0A 1ch Synchronous Buck Converter integrated FET
BD9132MUV
If VCC=3.3V, VOUT=1.8V, RONH=82mΩ, RONL=70mΩ
IOUT=3A, for example,
D=VOUT/VCC=1.8/3.3=0.545
RON=0.545×0.082+(1-0.545)×0.07
=0.0447+0.0319
=0.0766[Ω]
P=32×0.0766=0.6894[W]
Datasheet
As RONH is greater than RONL in this IC, the dissipation increases as the ON duty becomes greater. With the
consideration on the dissipation as above, thermal design must be carried out with sufficient margin allowed.
Selection of Components Externally Connected
1. Selection of inductor (L)
IL
VCC
IL
L
ΔIL
VOUT
Co
Fig.28 Output ripple current
The inductance significantly depends on output ripple current.
As seen in the equation (1), the ripple current decreases as the
inductor and/or switching frequency increases.
(VCC-VOUT)×VOUT
ΔIL=
L×VCC×f
[A]・・・(1)
Appropriate ripple current at output should be 20% more or less of the
maximum output current.
ΔIL=0.2×IOUTmax. [A]・・・(2)
(VCC-VOUT)×VOUT
L=
ΔIL×VCC×f
[H]・・・(3)
(ΔIL: Output ripple current, and f: Switching frequency)
※Current exceeding the current rating of the inductor results in magnetic saturation of the inductor, which decreases
efficiency. The inductor must be selected allowing sufficient margin with which the peak current may not exceed its current
rating.
If VCC=5.0V, VOUT=2.5V, f=1MHz, ΔIL=0.2×3A=0.6A, for example,(BD9132MUV)
(5-2.5)×2.5
L= 0.6×5×1M =2.08μ → 2.2[μH]
※Select the inductor of low resistance component (such as DCR and ACR) to minimize dissipation in the inductor for better
efficiency.
2. Selection of output capacitor (CO)
VCC
VOUT
L
ESR
Co
Fig.29 Output capacitor
Output capacitor should be selected with the consideration on the stability region and the
equivalent series resistance required to smooth ripple voltage.
Output ripple voltage is determined by the equation (4):
ΔVOUT=ΔIL×ESR [V]・・・(4)
(ΔIL: Output ripple current, ESR: Equivalent series resistance of output capacitor)
※Rating of the capacitor should be determined allowing sufficient margin against output voltage.
A 22μF to 100μF ceramic capacitor is recommended.
Less ESR allows reduction in output ripple voltage.
www.rohm.com
© ROHM Co., Ltd. All rights reserved.
TSZ22111ï½¥15ï½¥001
12/18
TSZ02201-0J3J0AJ00140-1-2
02.MAR.2012 Rev.001