DS8816A Datasheet, PDF (7/21 Pages) Richtek Technology Corporation – Dual-Phase PWM Controller with PWM-VID Reference

RT8816A
Parameter
Reference
Reference Voltage
Driver On-Resistance
UGATE Driver Source
UGATE Driver Sink
LGATE Driver Source
LGATE Driver Sink
Dead-Time
Internal Boost Diode
Resistance
Symbol
Test Conditions
VVREF
Sourcing Current = 1mA, VID no
Switching
RUGATEsr
RUGATEsk
RLGATEsr
RLGATEsk
BOOTx  PHASEx Forced to 5V
BOOTx  PHASEx Forced to 5V
LGATEx, High State
LGATEx, Low State
From LGATE Falling to UGATE
Rising
From UGATE Falling to LGATE
Rising
RBOOT
PVCC to BOOTx, IBOOT = 10mA
Min Typ Max Unit
1.98
2
2.02 V
--
2
4

--
1
2

--
1.5
3

--
0.7 1.5 
--
30
--
ns
--
20
--
--
80
--

Note 1. Stresses beyond those listed “Absolute Maximum Ratings” may cause permanent damage to the device. These are
stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in
the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions may
affect device reliability.
Note 2. θJA is measured under natural convection (still air) at TA = 25°C with the component mounted on a high effective-
thermal-conductivity four-layer test board on a JEDEC 51-7 thermal measurement standard. θJC is measured at the
exposed pad of the package.
Note 3. Devices are ESD sensitive. Handling precaution is recommended.
Note 4. The device is not guaranteed to function outside its operating conditions.
Note 5. Not production tested. Test condition is VIN = 8V, VOUT = 1V, IOUT = 20A using application circuit.
Copyright ©2016 Richtek Technology Corporation. All rights reserved.
DS8816A-00 September 2016
is a registered trademark of Richtek Technology Corporation.
www.richtek.com
7