X8200 Datasheet, PDF (6/19 Pages) rfsolutions.ltd – Synthesised Radio Modem

Synthesised Radio Modem
X8200
X8200HP
4.3 Factory Setting
The radio modem is supplied with the following settings:
X8200 Radio Modem V#.#
Advanced Menu Y
Modem ID
01
Baud
9600
Parity
N
Odd/Even
E
RF Power
5
Key Transmitter N
RF Channel
17
RSSI
N
Sensitivity
00
Comms Speed S
Address Mode N
Enable AT Instr N
Restore Defaults N
Exit without Save N
Save & Exit
N
Advanced Menu
Return to Main Menu
Message Tag
TX Priority
FEC
Packetise Data
Number of Retries
Packet Size
Logger Mode
Enable Remote Access
Access Remote Modem
Engage Repeater Path
Set Repeater Path
Y
0000
N
N
N
05
20
N
Y
N
N
00
M01 M02 M03 M04 M05 M06 ---- M16
4.4 Plug and Play
Connect three wires to the RS232 serial port of the host terminal (0V, TD and RD) as
described above. Connect a regulated power supply to the radio modem. X7202 PC to
Modem cables can be used along with a X7201 power supply.
Configure a PC to Hyperterminal in the Accessories section to the following:
Go to File and then t Properties.
Set the Configuration to :
9600 Baud
No Parity
1 Stop Bit
XON/XOFF to OFF
RTS/CTS to OFF (no handshaking)
Settings should be: Terminal Keys set
Emulation set to ANSI
ASCII Set Up : Deselect all.
Connect up a second modem in the same way.
Pressing a key on one PC will transmit the character to the other. Refer to the Section 8.0
Trouble Shooting if this does not happen.
DS8200-2 April ’07
©2007 RF Solutions Ltd, www.rfsolutions.co.uk
Page 6