RH850F1L Datasheet, PDF (7/16 Pages) Renesas Technology Corp – Emulator

RH850/F1L Series E1/E20 Emulator Release Note(Restrictions when using CubeSuite+)
No. 11 Regarding controlling execution function(Power save mode)
[Description]
The device leaves the STOP or deep STOP mode in response to any of the following operations.
a) Break
b) Memory access
c) Forcibly stopping tracing
d) Setting an event
e) Enabling the delay stop or full stop in tracing
[Resolution]
None
No. 12 Regarding controlling execution function(snooze instruction)
[Description]
When a snooze instruction is executed in single step (SS) mode and interruption is inputted into the stop state by
snooze instruction, SS exception by the completion of snooze instruction execution does not occur, Since SS
exception occurs after executing the top instruction to an interrupt handler, it seems that the snooze instruction
was slippery.
[Resolution]
None
No. 13 Regarding controlling execution function (interrupt/exception instruction/CALLT instruction)
[Description]
When the instruction which is next to step execution of interrupt, exception instruction or CALLT instruction is
LDSR or STSR which operates system register (PSW, EIIC, FEIC, EIPSW, FEPSW), a value may not be
reflected to those registers correctly.
[Resolution]
None
No. 14 Regarding Break/Event function(SYSCALL instruction)
[Description]
A read-access break cannot be used to the data-access of a SYSCALL instruction.
[Resolution]
None
No. 15 Regarding Break/Event function(during a clock setup)
[Description]
When E1 emulator be taken a break during a clock setup, rewriting of a flash memory becomes impossible.
[Resolution]
None
R20UT2743EJ0200 Rev.2.00
Mar 20, 2014
Page 7 of 13