H83068F Datasheet, PDF (695/935 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

20.6 Module Standby Function
Section 20 Power-Down State
20.6.1 Module Standby Timing
The module standby function can halt several of the on-chip supporting modules (SCI2, SCI1,
SCI0, the DMAC, 16-bit timer, 8-bit timer, DRAM interface, and A/D converter) independently
in the power-down state. This standby function is controlled by bits MSTPH2 to MSTPH0 in
MSTCRH and bits MSTPL7 to MSTPL0 in MSTCRL. When one of these bits is set to 1, the
corresponding on-chip supporting module is placed in standby and halts at the beginning of the
next bus cycle after the MSTCR write cycle.
20.6.2 Read/Write in Module Standby
When an on-chip supporting module is in module standby, read/write access to its registers is
disabled. Read access always results in H'FF data. Write access is ignored.
20.6.3 Usage Notes
When using the module standby function, note the following points.
DMAC: When setting a bit in MSTCR to 1 to place the DMAC in module standby, make sure
that the DMAC is not currently requesting the bus right. If the corresponding bit in MSTCR is set
to 1 when a bus request is present, operation of the bus arbiter becomes ambiguous and a
malfunction may occur.
DRAM Interface: When the module standby function is used on the DRAM interface, set the
MSTCR bit to 1 while DRAM space is deselected.
On-Chip Supporting Module Interrupts: Before setting a module standby bit, first disable
interrupts by that module. When an on-chip supporting module is placed in standby by the module
standby function, its registers are initialized, including registers with interrupt request flags.
Pin States: Pins used by an on-chip supporting module lose their module functions when the
module is placed in module standby. What happens after that depends on the particular pin. For
details, see section 8, I/O Ports. Pins that change from the input to the output state require special
care. For example, if SCI1 is placed in module standby, the receive data pin loses its receive data
function and becomes a port pin. If its port DDR bit is set to 1, the pin becomes a data output pin,
and its output may collide with external SCI transmit data. Data collision should be prevented by
clearing the port DDR bit to 0 or taking other appropriate action.
Register Resetting: When an on-chip supporting module is halted by the module standby
function, all its registers are initialized. To restart the module, after its MSTCR bit is cleared to 0,
Rev. 3.00 Sep 14, 2005 page 673 of 910
REJ09B0258-0300