 English |
|
|
|
|
|
|
|
| H8S2164 Datasheet, PDF (685/906 Pages) Renesas Technology Corp – 16-Bit Single-Chip Microcomputer H8S Family / H8S/2400 Series | |||
| |||
| ◁ |
Section 21 Flash Memory
21.1.1 Operating Mode
When each mode pin and the FWE pin are set in the reset state and reset start is performed, this
LSI enters each operating mode as shown in figure 21.2.
⢠Flash memory can be read in user mode, but cannot be programmed or erased.
⢠Flash memory can be read, programmed, or erased on the board only in boot mode, user
program mode, and user boot mode.
⢠Flash memory can be read, programmed, or erased by means of the PROM programmer in
programmer mode.
Reset state
RES = 0
Programmer mode setting
Programmer
mode
User mode
RES
User
=0
mode
setting
Boot
RES =
mode setting
0
FLSHE = 0
â FWE = 0
FWE = 1 â
User program
mode
User boot
mode
FLSHE = 1
On-board programming mode
Boot mode
Figure 21.2 Mode Transition of Flash Memory
Rev. 1.00 Mar. 17, 2008 Page 645 of 862
REJ09B0429-0100
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese