|
M16C5M_15 Datasheet, PDF (4/159 Pages) Renesas Technology Corp – RENESAS MCU | |||
|
◁ |
M16C/5M Group, M16C/57 Group
1. Overview
Table 1.3 Specifications (80-pin Package) (1/2)
Item
CPU
Function
Specification
M16C/60 Series CPU Core (Multiplier: 16 Ã 16 32 bits, Multiply-accumulate
unit: 16 Ã 16 + 32 32 bits))
Central processing unit ⢠Basic instructions: 91
⢠Minimum instruction execution time:
⢠Operating mode: Single-chip mode
Memory
ROM, RAM, data flash,
E2dataFlash
See Table 1.7 to Table 1.10.
Voltage
Detection
Voltage detector
⢠2 voltage detect points
Clock
Clock generator
⢠5 circuits (Main clock, sub clock, PLL frequency synthesizer, 125 kHz on-
chip oscillator, 40 MHz on-chip oscillator)
⢠Oscillation stop detector: Main clock oscillator stop/restart detection
⢠Frequency divide circuit: Divide-by-1, 2, 4, 8, or 16 selectable
⢠Low-power consumption modes: Wait mode, stop mode
⢠Real-time clock
I/O Ports
Programmable I/O
ports
⢠70 CMOS inputs/outputs, a pull-up resistor selectable
⢠N-channel open drain ports: 1
Interrupts
⢠Interrupt vectors: 70
⢠External interrupt inputs: 11 (NMI, INT à 6, key input à 4)
⢠Interrupt priority levels: 7
Watchdog Timer
⢠15 bits à 1 (with prescaler)
⢠Automatic reset start function selectable
⢠Dedicated 125 kHz on-chip oscillator for the watchdog timer contained
DMA
DMAC
⢠4 channels, Cycle-steal transfer mode
⢠Trigger sources: 43
⢠Transfer modes: 2 (single transfer, repeat transfer)
Timer A
16-bit timer à 5
Timer mode, event counter mode, one-shot timer mode, pulse-width
modulation (PWM) mode
Two-phase pulse signal processing in event counter mode (two-phase
encoder input) Ã 3
Programmable output mode à 3
Timers
Timer B
16-bit timer à 3
Timer mode, event counter mode, pulse frequency measurement mode,
pulse-width measurement mode
Timer function for three- Three-phase motor control timer à 1 (timers A1, A2, A4, and B2 used)
phase motor control On-chip dead time timer
Timer S (Input capture/ ⢠16-bit timer à 1 (base timer)
output compare)
⢠I/O: 8 channels
Task monitoring timer 16-bit timer à 1 channel
Real-time clock
Count: seconds, minutes, hours, weeks
Serial
Interface
UART0 to UART4
4 channels (UART, clock synchronous serial interface)
1 channels (UART, clock synchronous serial interface, I2C-bus, IEBus)
Multi-master I2C-bus Interface
1 channel
A/D Converter
10-bit resolution à 27 channels
D/A Converter
8-bit resolution à 1 channel
R01DS0019EJ0110 Rev.1.10
Sep 01, 2011
Page 4 of 156
|
▷ |