H8S2245 Datasheet, PDF (378/818 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family / H8S/2200 Series

Section 9 16-Bit Timer Pulse Unit (TPU)
9.4.6 Phase Counting Mode
In phase counting mode, the phase difference between two external clock inputs is detected and
TCNT is incremented/decremented accordingly. This mode can be set for channels 1, and 2.
When phase counting mode is set, an external clock is selected as the counter input clock and
TCNT operates as an up/down-counter regardless of the setting of bits TPSC2 to TPSC0 and bits
CKEG1 and CKEG0 in TCR. However, the functions of bits CCLR1 and CCLR0 in TCR, and of
TIOR, TIER, and TGR are valid, and input capture/compare match and interrupt functions can be
used.
When overflow occurs while TCNT is counting up, the TCFV flag in TSR is set; when underflow
occurs while TCNT is counting down, the TCFU flag is set.
The TCFD bit in TSR is the count direction flag. Reading the TCFD flag provides an indication of
whether TCNT is counting up or down.
Table 9.7 shows the correspondence between external clock pins and channels.
Table 9.7 Phase Counting Mode Clock Input Pins
Channels
When channel 1 is set to phase counting mode
When channel 2 is set to phase counting mode
A-Phase
TCLKA
TCLKC
External Clock Pins
B-Phase
TCLKB
TCLKD
Example of Phase Counting Mode Setting Procedure
Figure 9.25 shows an example of the phase counting mode setting procedure.
Phase counting mode
Select phase counting mode [1]
[1] Select phase counting mode with bits MD3
to MD0 in TMDR.
[2] Set the CST bit in TSTR to 1 to start the
count operation.
Start count
[2]
<Phase counting mode>
Figure 9.25 Example of Phase Counting Mode Setting Procedure
Rev.3.00 Mar. 26, 2007 Page 336 of 772
REJ09B0355-0300