R1EX24064ASAS0A_15 Datasheet, PDF (14/26 Pages) Renesas Technology Corp – Two-wire serial interface 64k EEPROM (8-kword × 8-bit)

R1EX24064AxxS0A
Write Operations(WP=Low)
Byte Write: (Write operation during WP=Low status)
A write operation requires an 8-bit device address word with R/W = “0”. Then the EEPROM sends
acknowledgment "0" at the ninth clock cycle. After these, the 64kbit EEPROM receives 2 sequence 8-bit
memory address words. Upon receipt of this memory address, the EEPROM outputs acknowledgment "0"
and receives a following 8-bit write data. After receipt of write data, the EEPROM outputs
acknowledgment "0". If the EEPROM receives a stop condition, the EEPROM enters an internally-timed
write cycle and terminates receipt of SCL, SDA inputs until completion of the write cycle. The EEPROM
returns to a standby mode after completion of the write cycle.
Byte Write Operation
WP
Device
address
64k ^{1 0 1 0}
Start
1st Memory
address (n)
W
ACK
R/W
Note: 1. Don't care bit
2nd Memory
address (n)
Write data (n)
ACK
ACK
ACK _Stop
REJ03C0332-0200 Rev.2.00 Oct. 26, 2009
Page 12 of 22