PD168103_15 Datasheet, PDF (11/22 Pages) Renesas Technology Corp – 5-CHANNEL OPERATIONAL AMPLIFIER, IRIS DRIVER, AND 4-CHANNEL H-BRIDGE DRIVER

µ PD168103
6. ELECTRICAL SPECIFICATIONS
Absolute Maximum Ratings (TA = 25°C, glass epoxy board of 100 mm x 100 mm x 1 mm with copper foil area
of 15%)
Parameter
Symbol
Condition
Rating
Unit
Power supply voltage
LVDD
Control block
−0.5 to +6.0
V
AVDD
Analog block
−0.5 to +6.0
V
Input voltage ^Note1
VM12, VM34
Stepping motor block
VSHUTTER, VIRIS IRIS block
VIN
−0.5 to +6.0
V
−0.5 to +6.0
V
−0.5 to LVDD + 0.5
V
Output pin voltage 1
VOUT1
Motor block
6.2
V
Output pin voltage 2
VOUT2
Amplifier block
−0.5 to AVDD + 0.5
V
DC output current
ID1(DC)
DC (stepping motor)
±0.3
A/ch
ID2(DC)
DC (IRIS)
±0.2
A/ch
Instantaneous output current
ID(pulse)
PW < 10 ms, Duty Cycle ≤ 20%
±0.7
A/ch
Power consumption
Peak junction temperature ^Note2
PT
Tch(MAX)
1.0
W
150
°C
Storage temperature
Tstg
−55 to +150
°C
Notes 1. Keep VIN to less than 6 V.
2. The overheat protection circuit operates at Tch > 150°C. When overheat is detected, all the circuits are
stopped. The overheat protection circuit does not operate at reset or on detection of ULVO.
Caution Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage, and therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
Recommended Operating Conditions (TA = 25°C, glass epoxy board of 100 mm x 100 mm x 1 mm with copper
foil area of 15%)
Parameter
Symbol
Condition
MIN.
TYP.
MAX.
Unit
Power supply voltage
LVDD
Control block
2.7
3.6
V
AVDD
Analog block
4.5
5.5
V
VM12, VM34
Stepping motor block
2.7
5.5
V
VSHUTTER, VIRIS IRIS block
2.7
5.5
V
Input voltage
DC output current
VIN
ID1(DC)
0
DC (stepping motor, when 2 chs are −0.2
driven at same time)
VDD
+0.2
V
A/ch
ID2(DC)
DC (IRIS), maximum current when −0.1
the shutter operates
+0.1
A/ch
Amplifier output current
IOUT_AMP1
AMP1 to AMP3
−5
+5
mA/ch
Amplifier output sink current
IOUT_AMP2
AMP4
0
+5
mA
Logic input frequency
fIN
Operating temperature range TA
100
kHz
−10
70
°C
Caution Design each output current so that the junction temperature does not exceed 150ºC.
Data Sheet S17332EJ1V0DS
9